I just had these floors refinished a year ago and cannot afford to have them done again.
My floors have a polyurethane finish and I have read that I should never use oil based cleaners. Apparently it creates problems if you want to recoat the polyurethane. The wood isn’t discolored, the polyurethane is. Looks like a chemical reaction to the waffle pad material. HELP!!!
On 06.07.10, In Q&A, By Admin
On 06.01.10, In Q&A, By Admin
On 05.29.10, In Q&A, By Admin
I uncovered hardwood floors in my house that had 2 layers of plywood and 5 layers of tar paper to vinyl tile. A total of 7/8 inch thick. at this point they are covered in sheet rock mud,sand, adhesive in some areas and dirt.I need to clean this off before refinishing the floors what is the best way?
On 05.26.10, In Q&A, By Admin
On 05.23.10, In Q&A, By Admin
On 05.21.10, In Q&A, By Admin
On 05.20.10, In Q&A, By Admin
We’re doing a kitchen remodel on our 100 year old American foursquare. After removing a vinyl & a linoleum floor, we came to a maple floor, with a layer of paper (from the linoleum?) glued to it. There were also nails between every board, along the joists; evidently added to reduce the squeeks before the linoleum was laid. The kitchen is about 240 sf.
The floor expert said the paper wasn’t a problem; it should sand off. But he said he’d have to sand off each nail head before refinishing the floor, which would probably loosen up the floor & leave lots of nail holes. He recommended replacing.
Our cabinet maker suggested countersinking all the nails, refinishing, and enjoying the patina.
When our contractor countersank a few nails, it pushed the boards apart (tightening them, but also creating an ever-so-slight gap). It was also hard work; he recommended replacing.
What to do? Refinish the current maple floor (~$2k), or remove & replace (oak is ~$1k, maple ~$2k, extra)?
